To successfully test a sing-box network,follow these organized steps:

Setup Configuration

• Ethn Switch and Switch Controller: Connect the Ethn switch to the Ethn switch controller, which should be connected to the switch tower (central base station).
• Switch Controller: Ensure it is correctly configured and tested for performance.

Wireless Testing

• Wireless Bridge: Use a wireless bridge to connect the switch controller to the network. This allows testing the network in a wireless environment.
• Test Signal: Send a test signal through the wireless bridge to ensure the network is functioning correctly in a wireless context.

Physical Layer Testing

• Physical Layer Layer 1 Test: Send a test signal through the physical layer and measure the response to ensure proper connection and functionality.
• Physical Layer Layer 2 Test: Check the network layer 1 layer 2 connections to ensure data routing is correct.
• Physical Layer Layer 3 Test: Test the layer 3 connections to verify routing and congestion control algorithms.

Wireless Layer 3 Test

• Test Signal: Use a test signal to ensure the wireless layer 3 connections are functioning correctly, focusing on routing and congestion control.

Ensure Everything Works

• Physical Connections: Verify that all Ethernet cables are properly installed and functioning.
• Switch Functionality: Check that the Ethn switch and switch controller are operating as expected.
• Layer 2 and Layer 3 Functionality: Ensure the network layer 1 layer 2 and layer 3 connections are functioning correctly.

Additional Considerations

• Clean Bus: Ensure the physical layer has a clean bus to avoid issues like clock skew.
• Layer 1, 2, and 3 Tests: Perform thorough tests on each layer to ensure comprehensive network functionality.

By following these steps, you can effectively test a sing-box network and ensure its robustness and reliability.